Drilling Porcelain Tiles : Step-by-Step Guide

Drilling Porcelain Tiles: Step-by-Step Guide

Would you like to learn how is drilling porcelain tiles done? This post will guide you by providing easy steps that are imperative for your drilling process. Drilling porcelain tiles will be necessary if you need to put up equipments in your bathroom or any room that has porcelain tiles. For example, by drilling the porcelain tiles, you will be equipped to put bathroom shaving cabinet, a mirror, soap dish, towel rails, or maybe your bath and body products holder.

To begin your drilling activity, you should first determine what kind of resources you’ll need to carry out the activity. Here are the tools you need:

RCD Breaker
Drill Bits of Diamond Core (Good Quality)
Masonry Drill Bits (Bundled w/ quality drill bits)
Drill Bit of Carbide Pilot ( this can be used if you’ll drill 13-mm hole or larger holes)
Equipment for Water Cooling
Drilling Device
Safety Glasses or Goggles

These materials can be bought in various stores. You could simply get these before proceeding with your drilling activity. You have to make sure of the quality of the instruments first to ensure the output of the drilling would be appropriate for your requirement.

Yet another thing that you should think about with drilling porcelain tiles is the hole sizes you’re going to create. This is fairly important for the size or diameter of the hole will determine how big the drill bit you’re going to use.

After establishing the diameter of the holes you’re going to drill and setting up the tools you’ll need for the drilling, you can start to proceed drilling your porcelain tiles. Make sure to put on your safety goggles to keep your eye away from dirt not to mention elimination of electric shock with RCD.

These proceeding steps would be for holes about 10mm or less in diameter with diamond cores.

1. Put an indication at the hole’s center. Either utilize a sticky tape or simply a lead pencil.
2. Grab the correct size of the diamond core bit. After that, affix it to the electric drill. Be sure there’s a supply of water from any cooling gear is at a constant. (Water cooling devices are important in keeping it certain that there’s a constant cool temperature in the diamond core bit and will also prevent debris as you are drilling the hole. Don’t use handheld aspirator or wet sponge, for these never render adequate coolant to the diamond core bit.)
3. Your drill should be positioned between 1000 & 1500 rpm. Preferring the marker as a marking tool, it is suitable to apply the “Leaning In” method.
*Method of Leaning In- With an angle, you will begin to drill. When you see the drill cuts the tile, your drill must remain in horizontal position. Ensure that there’s enough pressure laid and rotate the drill until the hole is fully drilled.
*Method using Sticky tape- Put sticky tape on the wall exactly where you want the hole. This will help to stop the drill bit from slipping.
4. Tip- I picked up a great from www.tfo.com.au. As soon as the hole has started, don’t use excessive pressure let the drill do the work.

{ 0 comments… add one now }

Leave a Comment

Previous post:

Next post: